Other Messages - DeVilbiss Healthcare SmartLink DV5M Guía De Instrucciones

operATIon
Message shown if an error is encountered during card data
transfer. This message will remain on the display until
acknowledged by pressing any key on the keypad or a 15 minute
timeout occurs.
Message shown if an error is encountered while updating device
settings. This message will remain on the display until
acknowledged by pressing any key on the keypad or a 15 minute
NOTE
timeout occurs.
contact your clinician.
Message shown after removing the card from the module. This
message will remain on the display for ten seconds.
Message shown when a new module with mismatched data is
detected. This message will remain on the display until the
module is removed. Contact your provider to notify them of
the situation and for instructions on how to resolve the issue. If
this situation is not resolved, the module will not be able to record usage and therapy data.
However, although this message will remain on the display with the module attached, the
CPAP will still be functional and provide therapy.

Other Messages

In the unlikely event that a fault should occur, this message will
be shown when a module fault condition is encountered (Clock
Error, Memory Error, Setting Error, etc).
Message shown when firmware is being updated. This message
will remain on the display until the update is complete.
Occasionally a firmware update may be provided for your device
via SmartLink Data Card. The firmware update process is automatic and may take a few
seconds to complete. Once the update is complete, the system will return to normal
operation.
–If this message is displayed,
EN
Card Error
Contact Provider
Setting Error
Contact Provider
Card Removed
Send to Provider
Setup Required
Contact Provider
E00 Module Fault
Contact Provider
Firmware Update
Please Wait . . .
A-DV5M-1
11