Specifications - DeVilbiss Healthcare SmartLink DV5M Guía De Instrucciones

EN
Problem
Settings error.
Setup required.
Oximeter data
(SpO and PR)
2
not displayed.
CPAP is not fully
functional.
DEVILBISS SMARTLINk SPECIFICATIONS
Size: ............................................. 3.9" H x 3.1" W x 1.4" D (9.9cm H x 7.9cm W x 3.6cm D)
Weight: .......................................................................................................... 0.30 lbs. (0.14 Kg)
Electrical Rating:
Maximum Power Consumption (SmartLink Module only): .................................................4 W
Voltage and Current: ............................................ Power supplied by the DV5X Series Device
Class II Equipment; Type BF Applied Parts; Continuous Operation
14 A-DV5M-1
TroubleshooTIng / specs
Probable Cause
1. Card removed
during data transfer.
2. Card corrupt or
faulty.
1. Module not set up
properly.
1. Oximeter not
properly connected
to the SmartLink
module.
2. Oximeter probe not
properly attached to
user.
1. Module may be
defective.
Remedy
1. Card must not be removed during data
transfer. Data transfer interruption may
corrupt the card and prevent the card
from working correctly. Reinsert card and
allow data transfer to continue until
completed. If this error is not corrected,
contact provider for resolution.
2. Return card to provider for replacement.
If this error is not corrected, contact
provider for resolution.
1. Notify provider of the situation and follow
provider instructions.
1. Verify connection between the oximeter
connector and module oximeter
connection port.
2. Reference the operating instructions that
came with oximeter.
1. Remove the module from the CPAP and
verify that CPAP is fully functional. If it
functions properly without the module
connected, the module may be defective.
Contact provider. If it still is not fully
functional, consult the CPAP instruction
guide for troubleshooting.