Grill Lighting Instruction - Nexgrill 720-0718C Instrucciones De Montaje Y Funcionamiento

Checking for LP gas leaks
Never test for leaks with a flame. Prior to first use, at
the beginning of each season, or every time your LP
gas tank is changed, you must check for gas leaks.
1. Make a 50/50 (soap/water) mild soap solution.
2. Turn the control knobs to full OFF position; then
turn gas ON at supply tank.
3. Apply the soap solution with a clean brush to all
gas connections. See below. If growing bubbles
appear in the solution the connections are not
properly sealed. Check each fitting and tighten or
repair as necessary.
Gas Connection Leak Check
4. If you have a gas connection leak you cannot
repair, turn gas OFF at supply tank, disconnect
fuel line from your grill and call 1-800-913-8999 or
your gas supplier for repair assistance.
5. Also apply soapy solution to the tank seams. See
below. If growing bubbles appear, shut tank OFF
and do not use or move it! Contact an LP gas
supplier or your fire department for assistance.
Gas Tank Leak Check

Grill Lighting Instruction

Grill Lighting Instructions for Main Burners
1. Do not smoke while lighting grill or checking gas
supply connections.
2. Be sure that LP gas tank is sufficiently full.
WARNING
Failure to open grill lid during the lighting
procedure could result in a fire or explosion
that could cause serious bodily injury, death,
or property damage.
3. Be sure all gas connections are securely
tightened.
4. Open the Gas Grill Lid.
5. Push and turn any main burner knob to HIGH
position. Push Electronic ignition button for 3 to 5
seconds to light burner. Adjust knob to desired
setting.
6. If the burner does not light after 5 seconds, turn
knob to OFF. Turn gas OFF at LP tank and wait 5
minutes for gas to clear. Then turn gas ON at tank
and repeat step 5.
7. If burner still does not light, see Match Lighting
section and If Grill Still Fails to Light section on
following page.
8. To light additional burners, turn burner knob(s)
to HIGH. Push electronic ignition button for 3 to 5
seconds to light burner. Adjust knob(s) to desired
setting.
16