MTD 19A30003OEM Manual Del Operador página 11

Figure 4-11
Assembling Remaining Bagger Components
Now that the mounting brackets are assembled and are in place
on the tractor, follow these steps to assemble the remaining
bagger components.
1. Snap the plastic upper chute support in place by first
clipping the side portion onto the bag support rail with
the edge of the snap feature aligned with the red line (1), as
shown in the inset of Fig. 4-12.
2. Snap the front portion of the upper chute support to the
bag support rail as seen in 2 of Fig. 4-12.
2
Figure 4-12
3. Install the bagger screen into the bagger cover by first
inserting the end closest to the side with the cutout into
the mounting hole, as in Fig. 4-13. Make sure to feed the
screen under the lip, as in Fig. 4-14.
4. Clip in the other side by pushing the screen into the
provided cutout. See Fig. 4-14.
5. Install the grass catcher cover onto the bag support
assembly, as seen in Fig. 4-15. The grass catcher cover goes
inside of the two mounting tabs on the bag support assembly.
46" Decks
1
Make sure screen sits
under the cover's lip
Figure 4-13
Figure 4-14
Figure 4-15
s 4 — a & i
ectiOn sseMbly nstallatiOn
11