Installation Considerations; Important - Hansgrohe Ibox Universal Plus Rough 01850181 Instrucciones De Montaje / Manejo / Garantía

English

Installation Considerations

Know in advance what type of trim kit
is to be used. Installation requirements
vary. Additional valve(s) may be
required. Please refer to page 18.
• Some municipalities do not permit installations
that allow the use of two or more shower
functions simultaneously. Please know and
follow all applicable local plumbing codes.
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• Do not remove the plastic installation box from
the valve.
For correct function of the valve, the
hot supply must be plumbed to the hot
inlet (left) and the cold supply must be
plumbed to the cold inlet (right).
• The connections on the valve are ¾ NPT. ½ NPT
lines may be used if suitable for the installation.
The installer must provide ¾ - ½ adapters.
The outside surface of the finished wall
must fall between the "min" and "max"
markings on the iBox.

Important!

• The cartridge is included with the trim kit. The
cartridge will vary, according to the type of trim
kit.
• The cartridge has an integrated high temperature
limit stop which may be reset to comply with
local plumbing codes.
• To prevent scald injury, the maximum output
temperature of the shower valve must be no
higher than 120°F. In Massachusetts the
maximum output temperature of the shower
valve can be no higher than 112°F.
• Protect the rough from freeze damage. In the
event of freezing temperatures, drain the pipes.
3