Appliance Description; Safety System; Before First Use; Starting The Appliance - Moulinex JU2000 Manual De Instrucciones

A. Pusher
B. Feed tube
C. Cover
D. Sieve
E. Juice collector
F. Pouring spout

3. Safety system

This appliance has a built-in safety system. To start the juicer, the lid (C) must be fully locked by the
two locking clips (G).
At the end of the cycle, set the knob (I) to "0" and wait until the sieve has come to a complete stop
before removing the cover (C).
•
We recommend that you wash all removable parts (parts A, C, D, E, F, K) before using the
appliance for the first time (see Section 7).
• Remove the appliance from its packaging, then place it on a flat, stable, heat-resistant working
surface, remove the cover (C) and remove the protective cardboard from the sieve.

5. Starting the appliance

Place the pouring spout (F) on the juice collector (E) (fig. 1).
•
Place the juice collector (E) on the motor unit (H) (fig. 2).
•
Place the sieve (D) in the juice collector (E). Make sure that the sieve is correctly fitted onto the
•
drive shaft (fig 3).
• Position the cover (C) on the motor unit (H) (fig 4).
• Place the pulp container (K) on the back of the appliance (fig 5).
Position the 2 locking clips (G) on the lid (C) (fig. 6a and 6b): first lift the 2 clips (G) until you
•
hear the first "click" (fig. 6a); then press the bottom of each of the 2 clips (G) until you hear
another "click", which means they are fully locked (fig. 6b).
Place a glass under the pouring spout (F) at the front of the appliance.
•
Cut the fruit or vegetables into pieces after removing any pips if necessary.
•
Plug in the appliance. The cord storage (J) compartment lets you adapt the cord length.
•
Start the appliance using the start knob (I).
•
Insert fruit or vegetables using the filler (B).
•
Use the pusher (A), without forcing, to push the food down. Never use any other utensil.
•
Fruit and vegetables must always be fed into the appliance with the motor running.
Never apply excessive pressure to the pusher (A). NEVER PUSH with your fingers, always
use the pusher supplied.
Once you have finished, stop the appliance using the knob (I) and wait until the sieve (D)
•
has come to a complete stop.
When the pulp container (K) is full or when the flow of juice from the appliance slows, empty
•
the collector and clean the sieve (D).

2. Appliance description

G. Locking clips
H. Motor unit
I. On/Off switch
J. Cord storage
K. Pulp container

4. Before first use

6