Tabla de contenido
Light description and light pattern
Power light on, resume light blinks, right print cartridge light
turns on twice as long as off.
Power light on, resume light on, right print cartridge light turns
on twice as long as off.
Solving installation problems
This section provides troubleshooting suggestions for some of the most common problems associated with
hardware and software installation.
Problems printing
Check the printer to ensure the following
•
Power light is on and not blinking. When the printer is first turned on, it takes about a minute to
initialize.
•
No lights on the control panel are lit or blinking and that the printer is in the Ready state. If lights are lit
or blinking, see page 21.
•
Ensure power cord and other cables are working and firmly connected to the printer.
•
All packing tape and shipping materials are removed from the printer.
•
Print cartridges are properly installed in their correct carriage compartments. Press down firmly on each
one to ensure proper contact.
•
Ensure you have removed the tape from each print cartridge.
•
Ensure that the cartridges are not damaged.
•
Print cartridge latches and covers are closed.
•
Media is loaded correctly in the input tray and is not jammed in the printer.
Explanation and recommended action
Ink service module almost full.
•
If you have a replacement for the ink
service module, replace it immediately by
following the instructions that come with it.
•
Otherwise, visit:
http://www.hp.com/support/dj460
or call Customer Support to get a
replacement.
In the meantime, you can press
(Resume button) to continue printing, but
this light error state will remain until the ink
service module is replaced. When the ink
service module is full, the printer will stop
printing.
23
Tabla de contenido
