Alliance Laundry Systems HC18SN2 Operación Y Mantenimiento página 12

Operation
Display
FP 1 Program identification code (ROM)
(this is an example only)
HoLd Wait...power has just been turned on
CY Cycle (followed by two-digit number)
tESt/CYC* Test cycle selected
FAr Degrees Fahrenheit
CEL Degrees Celsius
HEAt Auxiliary heat enabled
noHt Auxiliary heat disabled
tFIL Temperature-controlled fill enabled
ntFL Temperature-controlled fill disabled
CooL Automatic cool-down enabled
noCL Automatic cool-down disabled
Ag 1 Agitation 1 selected (90% agitation)
Ag 2 Agitation 2 selected (33% agitation)
Ag 3 Agitation 3 selected (10% agitation)
Ag 4 Agitation 4 selected (6.7% agitation)
AgSn Agitation speed normal
AgSL Agitation speed low
n
PU P Pump output enabled (future use only)
n
nP P Pump output disabled (future use only)
PrE Prewash segment (1st of 11 segments)
UASH Wash segment (2nd of 11 segments)
FIL1 First fill (3rd of 11 segments)
FIL2 Second fill (4th of 11 segments)
FIL3 Third fill (5th of 11 segments)
FIL4 Fourth fill (6th of 11 segments)
FIL5 Fifth fill (7th of 11 segments)
FIL6 Sixth fill (8th of 11 segments)
FIL7 Seventh fill (9th of 11 segments)
FIL8 Eighth fill (10th of 11 segments)
FIL9 Ninth fill (11th of 11 segments)
CFIL Cold fill
bFIL Warm fill (both hot and cold)
HFIL Hot fill
AFIL Auxiliary fill (Setup option)
Lo Low water level
*Display indications separated by a slash (/) represent a flashing display.
10
Display Indications for V-Series – Non-Coin
Meaning
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Display
n
Ed Medium water level
HI High water level
SUP1 Supply 1
SUP2 Supply 2
SUP3 Supply 3
SUP4 Supply 4
SUP5 Supply 5 (Setup option)
SUP6 Supply 6 (supply 1 and 5)
SUP7 Supply 7 (supply 3 and 4)
SLo/For Gentle wash speed, forward direction
SLo/rEv Gentle wash speed, reverse direction
n
nor /For Normal wash speed, forward direction
n
nor /rEv Normal wash speed, reverse direction
drAI Drain enabled
nodr Drain disabled
dISt Distribution (load balancing before
extract)
n
SPIn/tI E* Reads "SPIn" for one second, then
"tI
SPn1 Lowest of three spins
SPn2 Middle of three spins
SPn3 Highest of three spins
STOP Stop routine
SdLY Spin coast delay
donE Cycle and stop routine have ended
dFLt Drive fault detected
door Door not properly closed
bAL/FAIL* Balancing routine failed during test cycle
after 10 attempts to balance load
FILL/STOP* Programmed water level not reached
after 30 minutes
FULL The computer detects low water level or
higher when none should be present
rotA Computer detects possible rotation of
motor when there should be none
tSFL Temperature sensor failure or
temperature out of range
Table 3
Meaning
n
E" followed by time for spin
F232137