Troubleshooting - Silvercrest SDBS 2400 A1 Instrucciones De Uso

Troubleshooting

Fault
The appliance is
not working.
The appliance
does not produce
any/produces too
little steam.
Water drips out
of the sole of the
iron 6.
Wet areas occur
on the goods be-
ing ironed.
NOTE
► If you are unable to resolve the problem by taking any of the aforemen-
tioned steps, please contact the service department.
■ 82 │ GB │ MT
Possible cause
Voltage supply error.
The appliance is not switched on. Switch the appliance on using
There is not enough water in the
water tank 0.
The appliance has not heated up
sufficiently.
The temperature control 2 has
been set in the
range.
The steam unit has not been used
for a long time or is being used
for the first time.
If steam ironing is paused briefly,
the cooling steam condenses
in the connecting hose 4. This
leads to drip formation.
The temperature you have set is
too low for steam ironing.
Such areas can be caused by
steam condensing on the ironing
board.
Remedy
Ensure that the plug is firmly
inserted into the power socket.
the On/Off button t.
Fill the water tank with water 0.
Wait until the temperature indica-
tor lamp 3 goes out.
Set a temperature suitable for
steam ironing (setting range
–
Press and hold down the steam
button 1. The steam takes a little
time until it discharges from the
sole of the iron 6.
This is normal. Hold the iron over
a collecting cloth or container
and press the steam button 1.
Steam will discharge from the
sole of the iron 6 instead of
water after a few seconds. You
can now continue ironing.
Set a temperature suitable for
steam ironing (setting range
First, wipe any wet areas off
the ironing board and then iron
the wet areas on the fabric dry
without steam.
).
).
SDBS 2400 A1