Best WCP3I Serie Manual De Instalación página 8

11. REINSTALL BLOWER (HORIZONTAL DISCHARGE ONLY)
1) Position the blower on the inner back of the hood, as shown on the right.
2) Using a 5/16" socket, or a Robertson or a Phillips no. 2 screwdriver and the 4 screws
previously removed, secure the blower to the hood.
NOTE: In order to ease installation, before mounting the blower, prepare the screw holes
by screwing all 4 screws without the blower, then remove and mount the blower.
3) Plug the blower connector back in and plug hood power cord into the outlet.
12. PLENUM INSTALLATION (NON-DUCTED INSTALLATION ONLY)
Remove the shipping tape retaining the lower and upper plenum plates with the 6" round adapter
together. Carefully align the upper plenum plate central notch with the line traced in step 8 (see
inset at right) and place it flush to the ceiling. Use the plate as a template to mark the position (A)
of its screws.
NOTE: To ease installation, there are many screw configurations: 6 in ceiling and 2 in wall, on each
side. Only 4 screws are needed to hold the top plenum plate.
Insert the included drywall anchors in the marked holes, then secure the upper plate using
4 no. 8 x 3/4" screws and washers (included with non-duct kit). Make sure the plate is tight against
the wall and ceiling.
Using 4 no. 8 x 3/8" provided screws, assemble the 6" round adapter to the lower plenum plate.
Assemble the lower plenum plate and 6" round adapter assembly to the upper plate by inserting
both tabs of the top plenum plate to their corresponding slots in lower plenum plate. Secure the
plenum assemby using 2 no. 8-18 x 3/8" screws (included).
8
HD0829
A
A
A
HD1024
HA0135
HD1025
R
IGHT SIDE
MOUNTING
SCREW
LOCATIONS