Otr (One Touch Recording); Copying A Video Cassette (Requires A Vcr Or Video Camera) - Sylvania 3819LC El Manual Del Propietario

OTR (One Touch Recording)

This function enables you to set a recording length simply
by pressing the REC/OTR button on the TV/VCR.
Make sure ...
TV/VCR power must be turned on.
Insert a cassette tape with its erase prevention tab in
place. (If necessary, rewind or fast forward the tape
to the point at which you want to begin recording.)
NOTES:
This function CANNOT be done from the remote control.
Recording starts immediately when the REC/OTR
button is pressed.
When the REC/OTR button is pressed 18 times, the
TV/VCR returns to the Normal Recording mode.
To stop the OTR operation, press the STOP button
on the TV/VCR or on the remote control.
To show the remaining time, press the DISPLAY button
on the remote control so that "OTR" appears on the TV
screen. (It will show up momentarily then disappear.)
Recording stops when 0:00 is reached.
Please note that in the SLP mode maximum recording
time, assuming the tape is started at the beginning,
is 8 hours using T-160 (or 6 hours using T-120).
If the tape runs out before the end time, the TV/VCR
will switch to the Stop mode immediately, ejects the
tape and turns itself off.
1
Select the channel to be recorded
Press the number buttons on the remote control or the
CHANNEL or button.
Remember: If the TV/VCR is connected to a cable box
or satellite box, the TV/VCR must be on CH3 or CH4,
then the channel to be recorded is selected on the cable
box or satellite box.
2
Begin OTR
Press the REC/OTR button on the
TV/VCR as many times as needed. The
recording length will be determined by
the number of times you press the
REC/OTR button. Each additional push will increase
the recording time by 30 minutes. It is set up to 8 hours.
Push(es) Display
1 push
2 pushes 0:30
3 pushes
1:00
↓ ↓
17 pushes 8:00
OTR ( 2 : 3 0 )
SP
Recording length
(normal recording)
30 minutes
60 minutes
↓
480 minutes
COPYING A VIDEO CASSETTE
(Requires a VCR or video camera)
You can make copies of video tapes made by friends or
relatives for your enjoyment.
WARNING: Unauthorized recordings of
copyrighted video tapes may be an
infringement of copyright laws.
Connect your TV/VCR and a Source (Playing) VCR
using the following diagram.
EARPHONE
Audio/Video
adapter cable
(not supplied)
1) Insert a pre-recorded video cassette into the Source
(Playing) VCR or video camera.
2) Insert a blank video cassette, or one you want to record
over, into the TV/VCR's cassette compartment.
3) Press the SPEED button on remote control for the
TV/VCR to select the desired recording speed
(SP/LP/SLP).
4) Press the CHANNEL
until "AUX" appears on the screen.
5) Press the RECORD button on the TV/VCR.
6) Begin playback of the tape in the source (Playing) VCR or video camera.
NOTE: For best results during dubbing, use the
TV/VCR's front panel controls whenever possible. The
remote control might affect the source (Playing) VCR's
playback operation.
- 23 -
[Fig.8]
AUIO IEO
[The TV/VCR]
[Ex: Source (Playing)
VCR or video camera]
IEO
OUT
IN
AUIO
or button on the TV/VCR
EN
7L26