8. Blade Assembly.
Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in one of the hardware packs. Hold
blade arm up to blade and align holes. Insert 3
blade attachment screws (along with washers)
with fingers first and then tighten screws
securely with a Phillips screwdriver. Repeat for
the remaining blades.
Remove blade arm screws and lock washers
from underside of motor. Align blade arm holes
with motor screw holes and attach blade arm
with lock washers and blade arm screws. Before
securing screws permanently, repeat with
remaining blade arms. Securely tighten all
screws.
Note: Tighten blade arm screws twice a year.
9. Light Kit Assembly (Optional).
Remove 3 screws from fitter plate.
Remove 1 screw from motor plate on underside
of motor housing and partially loosen the other 2
screws. Align slotted holes in fitter plate with
loosened screws in motor plate, allowing molex
connections from motor housing to come
through hole in middle of fitter plate. Twist fitter
plate to lock. Re-insert screw that was just
removed and securely tighten all 3 screws with
Phillips screwdriver.
If you wish to use the fan WITH the light kit,
connect WHITE wire from motor housing to
WHITE wire from light kit fitter. Connect BLACK
wire from motor housing to BLACK wire from
light kit fitter. Be sure molex connections snap
together securely.
Carefully arrange wires within fitter plate. Align
holes in light kit adaptor (at top of light kit fitter)
with holes in fitter plate. Re-insert screws that
were previously removed and tighten all 3 screws
securely.
["Light Kit Assembly" continued on next
page.]
lock washer and
blade arm screw
fitter plate
fitter plate
light kit fitter
page 7
motor housing
blade
attachment
screws
and washers
blade
blade arm
motor housing
motor plate
molex
connections
molex connections
light kit
adaptor