Disassembly Of Batch Bowl Parts - Waring Commercial WFP16SCD Manual De Instrucciones

DISASSEMBLY OF BATCH BOWL PARTS

ALWAYS UNPLUG THE UNIT BEFORE DISASSEMBLING.
• Remove the large food pusher from the feed tube. Remove the
small pusher from the large pusher.
Disassembly when removing the S-blade or
whipping disc
• Remove the batch bowl from the unit by rotating clockwise
(left) to disengage the tabs on the bottom of the bowl platform
from the batch bowl. When the bowl handle is on the left
(about 7 o'clock position), you can gently lift the bowl straight
up and out.
• Remove the lid from the batch bowl by pressing the tabs on
the handle and lifting up. The black seal can easily be removed
for cleaning.
It is recommended that you remove the bowl from the motor
base before you remove the S-blade or whipping disc.
NOTE: REMOVE ALL FOOD AND LIQUID BEFORE REMOVING
S-BLADE OR WHIPPING DISC, OR BOWL WILL LEAK.
• To remove the blade or disc, keep a slight downward pressure
on the top center hub of the blade or disc while removing the
bowl from the motor base. This will form a seal to prevent food
particles from spilling into the center tube of the bowl and onto
the motor base or the work surface. Remove all contents from
the batch bowl. Then remove the S-blade or whipping disc
from the bowl by pulling upward to unlock the seal. Handle the
S-blade with caution; the blades are extremely sharp.
Disassembly when removing an accessory disc
• Do not remove the batch bowl until the accessory disc is
removed.
• To remove an accessory disc, place your fingers on the outer
edge of two opposite sides of the disc and lift. The disc should
remove easily off the disc stem. If the disc stem stays attached
to the disc, hold the disc in one hand with the stem facing away
from your hand and pull out the disc stem. Be careful not to
scrape your hand on any sharp edges.
10