Automatic Charging - Samsung POWERbot SR20H9050U Serie Manual De Usuario

Steps to take if recharging is not being executed
Check the installation status of the
docking station when:
fthe docking station is located in a place where
POWERbot cannot easily access
fdistance of the docking station and POWERbot is
over 5 m apart
- It may take a long time for POWERbot to return to
the docking station for recharging

automatic charging

recharging
Low battery (Lo)
ENGLISH-11
When the battery indicator blinks
during cleaning, poWerbot will
return to the docking station to
charge itself automatically.
you may command poWerbot to
recharge at the docking station
while it is in cleaning process.
manually charge poWerbot by
placing it on the docking station.
manually charge poWerbot when:
fthe docking station is located in a corner
fbattery is fully exhausted
fPOWERbot is stuck by obstacles (furniture etc.)
fPOWERbot can't climb threshold near the docking
station (Height of the threshold that POWERbot can
climb: about 1.5 cm and below)
fwhen battery indicator blinks and "Lo" is displayed
fwhen POWERbot is set on Spot clean or Manual
clean mode