Troubleshooting - ProMed IRT-60 Instrucciones De Empleo

DIsPOsal
that should be recycled. Recycling also prevents uncontrolled waste disposal from damaging
the environment and human health. Therefore, please dispose of all waste devices using the
appropriate collection systems or send the device to the place of purchase for disposal. The
place of purchase will then recycle the device.
rechargeable batteries/batteries:
Do not throw your rechargeable batteries/batteries in the domestic waste, in fire, or in
water. Rechargeable batteries/batteries should be collected, recycled, or disposed of in an
environmentally friendly manner.
Only for eU countries:
According to the directive 91/157/EEc, defect or used rechargeable batteries/batteries must
be recycled. waste rechargeable batteries/batteries can be directly handed to:
Promed gmbH, Lindenweg 11, D-82490 Farchant.

trOUbleshOOtInG

DE
If you have problems while using the thermometer, solutions for the most common causes
EN
of errors can be found below. If the problem persists, please contact our customer service.
Problem
when performing a body
FR
temperature measurement,
measured values below
32° c (89.6° F) are
IT
shown on the display (b).
when carrying out the
ES
measurement, "Hi" is
shown on the display (b).
NL
RU
when performing the
PL
measurement, "Lo" is
shown on the display (b).
SE
FI
Possible cause
The thermometer has not been
set to the measuring mode
"Body".
The measured temperature
exceeds the maximum
thermometer's measuring range.
The measurement is impaired by
hair or sweat.
The measurement is impaired
by a draught or a significant
change in the ambient
temperature.
The measurements have been
carried out within too short an
interval and the thermometer did
not have enough time to restart.
The measuring distance is too
large.
20
Possible remedy
change the measuring mode
to "Body" according to the
instructions for use.
check the selected measuring
mode and change or adjust it if
necessary. If the measuring mode
has been set correctly, the object
to be measured may be too hot.
Make sure that the measurement
is not impaired by any obstacles
or moisture.
Make sure that no draught or
significant change in temperature
occurs while carrying out the
measurement.
Leave at least three (3) to
five (5) seconds between the
measurements; a 15-second
interval is recommended.
Repeat the measurements with the
recommended distance (approx.
3 - 5 cm, 1.2 to 2.0 in).