Battery Change; Switching The Unit Of Measurement; Calling And Deleting The Measured Values Saved; Switching On And Off The Signal Sound - ProMed IRT-60 Instrucciones De Empleo

battery chanGe

If the battery power is too low, the symbol (l) appears on the display (b) .
In order to change the battery, remove the battery compartment cover (I) from the battery
compartment (G) and remove the old battery (h). You can then insert the new battery into the
battery compartment (G) and slide the battery compartment (I) back onto the thermometer.

swItchInG the UnIt OF measUrement

In order to switch the thermometer's unit of measurement (celsius / Fahrenheit), you must
press the button (F) and it keep it pressed for two (2) seconds. By pressing the measuring
button (D), you can switch the unit of measurement. In order to save the set unit of
measurement, press the button (F) another four (4) times.

callInG anD DeletInG the measUreD valUes saveD

In order call measured values saved, you must first press the button (F) and then the memory
DE
button (e). You can then read the last measured value from the display (b). Every time
the memory button (e) is pressed, you call the preceding measured value. The Promed
Irt-60 thermometer saves the last 32 measured values.
EN
In order to delete the measured values, you must first press the button (F) and keep it
pressed for four (4) seconds and then repeat this using the memory button (e). As soon as a
beep sounds, all measured values are deleted. In order to check whether the deletion was
FR
successful, press the memory button (e) once more and the information "cLr" is shown on
the display (b).
IT

swItchInG On anD OFF the sIGnal sOUnD

In order to switch on or off the signal sound, press the button (F) and keep it pressed for two
ES
(2) seconds. Then press the button (F) again.
In order to switch on the signal sound, press the measuring button (D) and the information
"oN" is shown on the display (b). In order to switch off the signal sound, press the memory
NL
button (e) and the information "oFF" is shown on the display (b). In order to save the
setting, press the button (F) another three (3) times.
RU
care / maIntenance / stOraGe
PL
The promed thermometer Irt-60 is water-proof and therefore easy to clean and disinfect.
The measuring sensor (a) is the most sensitive part of the thermometer. only use a damp
SE
cloth or a cloth soaked in mild alcohol solution in order to clean it. Never immerse the
thermometer in water. Remove the battery from the thermometer when not using it for a
longer period of time. Never expose the thermometer to direct sunlight. Make sure that the
thermometer does not fall down.
FI
18