Tv Operating Mode - Promax US TV EXPLORER 2 User Manual

USER'S MANUAL. US TV EXPLORER II
If the highlighted measurement which appears on the measurement screen
corresponds to C/N, the Spectrum Analyser mode will measure the C/N ratio at the
frequency indicated by the marker and a second marker will indicate the frequency for
the noise measurement.
5.17

TV Operating Mode

When pressing the
EXPLORER II accedes to the TV mode, and tries to demodules on the monitor the
currently video signal on tune.
In the monitor will appear the TV picture with a window on the lower part to show,
for five seconds, in the case that the signal is analogue, the channel number, the
frequency, the active canalization, the colour system and the TV standard.
CHANNEL:
FCC
FR:
Figure 45.- Analogue channel monitoring.
NOTE: The symbol
instrument has detected a saturation condition for analogue signals in
the currently channel on tune. This symbol also appears, when the colour
subcarrier signal (Burst) does not contain information and therefore the
images are shown in black and white.
10/2007
[2] key from any mode of operation the US TV
14 60 Hz
NTSC M
471.25 MHz
in the upper corner of the screen indicates that the
Page 67