Safe Operation; Protective Measures; Installation With Bolt Attachment (C) - Oase LunAquaMaxi LED Set 1 Instrucciones De Uso

Safe operation

• Never operate the unit if either the electrical cables or the housing are defective!
• Do not carry or pull the unit by its electrical cable.
• Route cables/hoses such that they are protected from damage and do not present a tripping hazard.
• Only open the unit housing or its attendant components, when this is explicitly required in the operating instructions.
• Only carry out work on the unit that is described in this manual. If problems cannot be overcome, please contact an
authorised customer service point or, when in doubt, the manufacturer.
• Only use original spare parts and accessories for the unit.
• Never carry out technical modifications to the unit.
• Power connection cables cannot be replaced. If the cable is damaged, the unit must be disposed of.
• Only operate the unit with the supplied transformer.
• Keep the socket and power plug dry.
• The power pack and the plug connectors of the power cables supplied are not water-tight, but only rain and splash-
proof. Do not route or fit in the water.
• Do not look directly into the light source.
Installation
A T T E N T I O N ! Dangerous electrical voltage.
Possible consequences: Death or severe injury.

Protective measures:

• Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water: Isolate the
units and installations (switch off and disconnect from the power supply) before reaching into the water.
• Isolate the unit before starting any work.
• Secure the unit to prevent unintentional switching on.
• When installed above the water level, maintain a safety distance of at least 50 cm from combustible material. Ensure
a safe and stable seating. Do not cover the unit. Danger of fire!
• Position the unit in such a way that it does not present a hazard to anybody.
Setting up with the ground stake (B)
• Fully insert the ground stake (2) into the soil.
• Place the unit on the ground stake.
• Adjust the tilt of the light (F).

Installation with bolt attachment (C)

• Undo and remove bolt (11) and nut (8).
• Take out lamp (6).
• Wall or floor mounting (D): Bolt the foot (9) to a firm base or load bearing wall. Use the supplied dowel (10) and bolt
(7). Drill a 5 mm hole at least 35 mm deep.
• Mounting to ceiling: The supplied dowel (10) is not approved for mounting to ceiling and must not be used for this
purpose!
• Place the light on the foot and screw tight. Ensure that the nut (8) is in the small hole and the screw (11) with screw
cap (12) is in the large hole of the screw connection (13) and the detent tabs are engaged.
• Adjust the tilt of the light (F).
Connection (E)
• Connect the plug of the spotlight connection cable to the socket on the transformer and tighten the union nut (14)
hand-tight.
• To connect the Lunaqua Maxi LED Solo, disconnect the jumper plug (bridging plug) from the transformer and connect
the lamp directly.
- EN -
11