Intended Use; Installation And Connection - Oase LUNAQUA 3 LED Instrucciones De Uso

- EN -

Intended use

LunAqua 3 LED, referred to as "unit", may only be used as specified in the following:
• For use in water fountain systems and ponds.
• For use above and under water.
• Operate in accordance with instructions.

Installation and connection

 B
• Install the transformer at least 2 m from the edge of the pond.
• Position the unit in such a way that it does not present a hazard to anyone.
• Ensure safe and stable seating. Ensure the sufficient load carrying capacity of the wall or ground for installation on
the wall or on the base.
• For installation above water: Ensure a safety distance of at least 50 cm from combustible material.
Do not cover the unit!
Wall or ground installation
 C
• The base foot can either be placed on the ground or bolted to a firm base or load bearing wall.
Installation on the ground stake
How to proceed:
 D
1. Pull the spotlight sideways from the base foot.
2. Push the spotlight sideways onto the ground stake and push the ground stake almost completely into the ground.
Check its stability.
Tilting the unit
 E
• Turn the holding screw counterclockwise and tilt the unit as required. To fasten in place turn the holding screw clock-
wise.
Connect the unit
 F
• Connect the connection cable of the spotlight to the socket on the transformer and hand-tighten the union nut.
Commissioning/start-up
The unit will be destroyed if it is operated with a dimmer. It contains sensitive electrical components.
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
• Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
• Isolate the device (disconnect from the power supply) before carrying out any work on it.
Switching on: Insert the power plug of the transformer into the socket.
• Check the function of the spotlights.
Switching off: Disconnect the transformer power plug.
10
Fire hazard: