Assembly Instructions; Tools For Assembly; Assembly Requirements; Guide Bar / Saw Chain / Clutch Cover Installation - McCulloch EAGER BEAVER MS354a Manual Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

For Parts Call 606-678-9623 or 606-561-4983
For Parts Call 606-678-9623 or 606-561-4983
3-1. TOOLS FOR ASSEMBLY (YOUR SAW
WAS ASSEMBLED AT THE FACTORY)
You will need these tools to assemble your chain saw:
1.
Combination wrench-screwdriver (contained in your
user's kit or in lid of carry case).
2.
Heavy duty work gloves (user supplied).

3-2. ASSEMBLY REQUIREMENTS

Your new chain saw will require adjustment of chain, filling
the fuel tank with correct fuel mixture and filling the oil tank
with lubricating oil before the unit is ready for operation.
WARNING
DO NOT start saw engine until unit is properly prepared.
Read the entire user manual before attempting to operate
your unit. Pay particular attention to all safety precautions.
Your user manual is both a reference guide and handbook
provided to furnish you with general information to assem-
ble, operate and maintain your saw.
3-3. GUIDE BAR / SAW CHAIN / CLUTCH
COVER INSTALLATION
WARNING
Always wear protective gloves when handling chain.
TO INSTALL GUIDE BAR:
CAUTION
To ensure the bar and chain receive oil, ONLY USE THE
ORIGINAL STYLE BAR with the oil passage hole (A) as
illustrated above (Figure 3-3A).
1.
Make sure the CHAIN BRAKE
into the DISENGAGED position (Figure 3-3B)
2.
Remove the bar retaining nuts (B). Remove clutch
cover (C) by pulling straight out, some force may be
required. (Figure 3-3C)
NOTE: Discard the two plastic washers. They are only used
for shipping the chain saw.
3.
Using a screwdriver or the wrench supplied in the
user's kit or in the upper half of the carrying case. Turn
the adjustment screw (D) COUNTERCLOCKWISE
until the TANG (E) (projecting prong) is to the end of
its travel (Figure 3-3D).
4.
Place the slotted end of the guide bar over the bar bolt
(F). Slide guide bar behind clutch drum (G) until the
guide bar stops (Figure 3-3E).
A

3 - ASSEMBLY INSTRUCTIONS

®
lever is pulled back
3-3A
www.mymowerparts.com
www.mymowerparts.com
C
D
7
3-3B
B
3-3C
E
3-3D
F
G
3-3E
Tabla de contenido
loading

Este manual también es adecuado para:

Eager beaver eb356aEager beaver eb358a

Tabla de contenido