Cleaning - Maintenance; Cleaning & Maintenance; 1. Cleaning; 2. Everyday Disinfection - AirSep NewLife Intensity Manual Del Usuario

GB
NewLife Intensity
®
III. CLEANING - MAINTENANCE
III. 1. Cleaning
Only the outside of the NewLife Intensity is to be cleaned, with a dry cloth or, if necessary,
®
a damp sponge and clean or soapy water, then thoroughly dried with wipes and an alcohol-based
solution. A cetone, solvents or any other flammable products must not be used. Do not use
abrasive powders.
The removable dust filter (9) must be cleaned in soapy water after
approximately 100 hours of use, or when required. Rinse and
wipe dry. Fit a dry filter.
III. 2. Everyday disinfection
Due to the presence of the product filter inside the device,
everyday disinfection only concerns the external oxygen therapy
accessories: humidifier, probes, nasal cannulas (refer to the respective instructions for use).
The use of alcohol-based solutions means that the device must be
switched off.
a - The following minimum guidelines must be respected:
• Humidifier :
Daily:
-­ empty the water from the humidifier.
-­ rinse the humidifier flask under running water.
-­ Fill the humidifier up to the mark with slightly mineralised water.
Regularly:
- Disinfect the equipment by immersing them in a disinfectant solution (in general, we recommend
using water containing a small amount of chlorine bleach).
- Rinse and dry.
-­ Check that the humidifier lid seal is in good condition.
• Oxygen administration devices:
Follow the manufacturer's instructions.
b - For each new patient:
The humidifier must be sterilised if possible or changed. The NewLife Intensity must be
®
cleaned and disinfected as per the above instructions. The dust filter should preferably be changed.
The entire oxygen administration circuit (oxygen therapy nasal cannulas, etc.) must be changed.
AirSep Corporation
®
4-GB