Eaton Metalux LED SN Instrucciones De Instalación página 2

Installation Instructions – SN LED
INSTALLATION
SN LED Lens Instructions
Step 1:
Remove the lens and a parts bag including lens clips from
the incoming protective material.Wire according to code
(Figure 1.).
Step 2:
a. Insert the lens clip horizontally (Figure 2.).
b. Rotate the clip (Figure 3.).
c. Push the clip until the bottom flange engages in
the channel cover (Figure 4.).
Step 3:
a. Insert one side of the lens locating the edge of it
against the lens clips of the luminaire (Figure 5.).
b. Hinge the lens and slightly squeeze it in the areas
where the clips are present in the opposite side (Figure 6.).
c. Center the lens along the length of the luminaire
as needed (Figure 7 .).
d. Verify the lens is engaged in all (6) six locations per
4ft section.
Lens
Figure 1.
Figure 2.
2
Figure 3.
Channel Cover
Figure 4.
Figure 5.
Clip X 6
Figure 6.
Figure 7.
Installation Instructions – SN LED
0590SNLEDLNINS ADF140667 www.eaton.com