JVC TK-C676 Instrucciones página 7

#
!
@
(Setting switch side)
0
Cover
For protection against water drips. Slit the rubber cap on
this cover and pass the cable through the slits.
P. 14
!
Camera Connector (Female)
^
Connect to , the Male Connector on the camera.
@
Drop Prevention Hook
Attach the Drop Prevention Wire
the camera from falling.
#
Clamping Holes (x 4)
Attach the camera to a ceiling or to a Ceiling Flush Mount
Bracket (optionally available) using these holes.
$
[MACHINE ID] Switch
When an RS-485 communication system is used, for ex-
ample when using the camera in a system controlled by
an RM-P2580, set the camera IDs individually for each
camera.
P. 13
%
Setting Switches
Use these to set the PROTOCOL, etc.
P. 12
%
$
#
&
to this hook to prevent
^
⁄
)
^
Connector (Male)
!
Connect to , the Female Camera Connector on the Ceil-
ing Mount.
&
Drop Prevention Wire
Attach this wire to the Drop Prevention Hook
Ceiling Mount.
*
Camera Clamping Bracket
In order to clamp the camera onto the Ceiling Mount, in-
sert and tighten the Locking Screw
(
Lens
The lens cannot be replaced.
)
Dome Cover
The dome cover is fragile. Take care when handling it.
⁄
Camera Body Cover
Do not remove the camera body cover while the camera is
installed on a ceiling. Doing so will cause the dome cover
to fall down.
&
*
(
@
on the
4
into this bracket.
E-7