Cleaning Function - Unold 48935 Instrucciones De Uso

4. Do not use abrasive cleaners or implements such as steel wool, metal
scrapers, hot detergents or disinfectants.
5. After use, leave the ice cube maker open to prevent mould and bacterial
growth inside the appliance.
6. Before starting the appliance, make sure that the ice cube maker and the
power plug are completely dry.
7. Store the ice cube basket in a dry place and protected against dust, impact
and heat.
8. Important: If the ice cube maker has not been used for a prolonged period
of time, there might be air bubbles in the water pump. If this is the case,
the „Add Water" indicator is lit the moment you power the appliance. Press
the „ON/OFF" button to start the ice cube maker. If the problem persists,
contact our customer service department.

CLEANING FUNCTION

1. Fill the water tank to half the „Max." mark with fresh, clean water and add
a few drops of lemon juice or household vinegar.
2. Press the „Clean" button and then the „ON/OFF" button.
3. The appliance runs a cleaning process that takes about 150 seconds. During
this time, the „Ice Making" indicator is lit. For cleaning, the ice cube maker
pumps the water through the system, rinsing the water tank in the process.
4. While the cleaning process is running, do not switch off the appliance or
pull the power plug.
5. After cleaning is completed, the ice cube maker returns automatically to
standby mode.
6. Drain off the water through the water outlet.
7. Fill the water tank again to half the „Max." mark with fresh, clean water (no
additives).
8. Repeat the cleaning process to rinse out any residual lemon juice or vinegar.
9. When the process is completed, wait for approx. 1 minute and then drain off
the water through the water outlet.
Stand 25.1.2021
DE
EN
FR
NL
IT
ES
PL
29 von 96