golmar Rock Serie Manual De Instalación página 80

BACKBONE CODE PROGRAMMING
This device can work as a partial door panel in building complexes with shared entrances . In this
kind of systems, each partial door panel must be programmed with a different backbone code so
that shared entrances recognize which is the partial door panel they have to call.
To carry out this operation, do as follows.
NOTE: For this type of installation, please contact the technical trade department of Golmar.
B
ackbone code programming.
golmar
Find the configuration switch located in the rear part of the detached
house door panel and set number 5 to ON. Both door panels will
produce tones to indicate that program mode is enabled. The
coded door panel will display the "PROGRAM" message.
1 0
0 0 1
After programming the backbone, program monitors and telephones following the
instructions shown on p
Program all the other door panels in the same way.
Do NOT program more than one house door panel at the same time.
REMEMBER: It is necessary to program the backbone code only if the door panel is part of a system
equipped with general door panel/s (see note).
The general door panel enters programming mode
13:15
Insert the code of the backbone to be programmed
(between 1 and 250), then 001code and press the bell
button. Both door panels will produce tones to indicate
that programming has been succesfully carried out.
O.K.
In order to exit program mode, set microswitch number 5 of the
C
ANCEL
detached house door panel to OFF and press "C" button of
the general door panel.
age 72, 74 and 78.
after pressing the key button and inserting the
installer secret code (factory value 1315).
79