golmar Rock Serie Manual De Instalación página 73

72
P
rogramming the Tekna Plus monitors.
REMEMBER: Monitors must be programmed only
parallel units or if there are general door panels.
Find the configuration switch located in the rear part of the door panel
and set number 2 to ON.
The door panel will produce a tone, indicating that it has entered
program mode.
In systems with more than one door panel, this operation must be
carried out only in the main door panel of each building.
M S
Each apartment must have one master unit only; in case of parallel units configure them as slaves,
both monitors or telephones.
MONITOR PROGRAMMING
Switch off the monitor to be programmed.
Once the monitor is off, press the door release push button.
With the door release push button pressed switch on the
monitor.
To show that the system is ready for programming, the door
panel will reproduce a tone and the picture will appears
on the monitor. At this moment, the door release push
button can be released. Lift the handset to establish audio
communication with the door panel.
SI
Make a call to check that the monitor has been succesfully programmed.
Repeat these steps to program the rest of monitors.
Once the programming has been finished, set to OFF the programming
switch. If you don't, the door panel will reproduce a tone to advise that the
system is still into programming mode.
in case of installed
Press the door panel push button.
At this moment the door panel will
reproduce a tone and the monitor led will
blink.
To program the monitor as Master, switch it
off and on again.
To program it as Slave, press the door
release push button.
To program it as Slave + intercom function
press the push button.