O2 Monitor Test; On-Board Monitor Test; Component Test - BGS technic 6648 Manual De Instrucciones

4.6 O2 Monitor Test

To retrieve O2 monitor data:
1. Use the UP/DOWN key to highlight O2 Monitor Test from Diagnostic Menu and press the OK key.
Use the UP/DOWN key to highlight an O2 sensor and press the OK key to confirm.
2. Use the up and down arrow keys to scroll through data to select lines, and left and right arrow
keys to scroll back and forth through different screens of data.
3. Press OK key to view data of selection.
4. Press the ESC key to exit and return.

4.7 On-Board Monitor Test

The On-Board Monitor Test function is useful after servicing or after clearing a vehicle ECU's
memory. It receives test results for emission-related powertrain components and systems that are not
continuously monitored for Non-CAN vehicles. And for CAN vehicles, it receives test data for
emission-related powertrain components and systems that are and are not continuously monitored. It
is vehicle manufacturer who is responsible for assigning test and component IDs.
NOTE
Test results do not necessarily indicate a faulty component or system.
To request on-board monitor test results:
1. Use the UP/DOWN key to highlight On-Board Monitor Test from Diagnostic Menu and press the
OK key.
2. Depending on the protocol the vehicle used, one of these 2 screens shows.
3. Use the UP/DOWN key to highlight a test group and press the OK key to confirm. A screen with
details of the selected sensor displays. Use the up and down arrow keys to scroll through data to
select lines, and left and right arrow keys to scroll back and forth through different screens of
data.
4. Press the ESC key to exit and return.

4.8 Component Test

Component Test allows the code reader to control operation of vehicle components, tests or systems.
NOTE
•
Some manufacturers do not allow tools to control vehicle systems.
•
The manufacturer sets the criteria to automatically stop test. Refer to appropriate vehicle service manual before using this function.
To perform a component test:
Use the UP/DOWN key to highlight Component Test from Diagnostic Menu and press the OK key.
1. Use the UP/DOWN key to highlight a system or component, press the OK key to start test and
the code reader displays the message "Command Sent!".
2. Press the ESC key to exit and return.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
11
or
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed