Fitting And Removing The Wheels; Unfolding And Folding - JANE KENDO Manual Del Usuario

B. FITTING AND REMOVING THE WHEELS
To fit the rear wheels, keep the central button pressed while inser-
ting the wheel axle into the axle of the chassis until you feel it slot
securely into place.
1
To remove the rear wheels, keep the central button pressed and
take the wheel off the chassis.
To fit the front wheels, keep the front locking button pressed, slot
the front wheel onto the axle and push upwards. Release the front
locking button. You should feel it slot firmly into place.
To remove the front wheels, press the front locking button and
take the front wheel off by pulling it downwards.
WARNING: This action should never be carried out while the
!
baby is in the pushchair.
You should take the wheels off the chassis from time to time
!
and remove any dirt or sand from the wheel axle. Do not im-
merse the wheel bearings in water. Use a brush and a damp
cloth to clean the dirt off the wheels.
IM 2043_KENDO inst ALTA.indd 25
1
2
2
C. UNFOLDING AND FOLDING
UNFOLDING
To open your KENDO place it on a flat surface with the handlebar
facing upwards and unfasten the carry strap.
Lift the pushchair by the handlebar until it is fully unfolded and
you hear it lock into place.
4
WARNING: Before using your KENDO pushchair, make sure
!
that all the fastening and locking mechanisms are correctly
engaged and secure.
Adjust the handlebar to the required height by releasing the loc-
king levers and then fastening them again.
FOLDING
Before folding your KENDO pushchair, put the parking brake on
a, take anything out of the basket that could prevent the push-
7
chair from closing properly, release the steering lock on the front
wheels and remove any of the JANÉ accessories (KOOS, MICRO
8
or MATRIX seat).
3
12 a-12 b
EN 25
19/7/18 21:26