Tabla de contenido
SECTION 3 - INSTALLATION FOR NON-ELECTRIC MODELS
1. Place cabinet in rough-in and make sure cabinet is plumb and level. If cabinet is not plumb, shim as required.
2. Install four screws (SS674) followed by the screw caps (SS672) as shown. Insert the hole plugs (SS134) into the remaining four
holes.
3. Go to Section 4 for Final Assembly.
1
© 2019 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
Installation instructions
CB-216-1188 HARDWARE BAG
2
CB-211-1305
QTY: 6
CB-216-1188 HARDWARE BAG
[SS674]
CB-203-1349
QTY: 12
CB-211-1305
CB-SS672
QTY: 6
CB-211-1305
QTY: 6
CB-203-1349
QTY: 12
CB-203-1349
QTY: 12
CB-SS672
CB-SS134
QTY: 6
QTY: 6
CB-216-1188 HARDWARE BAG
CB-SS674
CB-SS712
QTY: 12
QTY: 8
[SS672]
CB-SS672
QTY: 6
[SS134]
CB-SS134
QTY: 6
QTY: 6
CB-SS674
QTY: 12
CB-SS674
CB-SS712
QTY: 12
QTY: 8
7
CB-SS136
QTY: 2
CB-203-1126
QTY: 6
CB-SS134
QTY: 6
CB-SS136
QTY: 2
CB-SS136
QTY: 2
CB-203-1126
QTY: 6
CB-SS712
QTY: 8
CB-203-1126
QTY: 6
Part no. 209-1311-rB rev. 08/21/19
Uplift Tech Cabinet
Tabla de contenido
