Tabla de contenido
SECTION 2 - ELECTRICAL CONNECTIONS FOR ELECTRIC MODELS
1. For electric models, E2 and E4, allow 24" (610 mm) of electric wire.
2. Using the supplied 3/32 Allen Key, remove the four screws to remove the right hand top ceiling panel inside the cabinet.
2a. This will give access to the electrical connection box.
3. Pull field wiring through the top holes and leave them hanging out of the Electrical Connection Box.
2
4. Place cabinet in rough-in and make sure cabinet is plumb and level. If cabinet is not plumb, shim as required.
5. Install four screws (SS674) followed by the screw caps (SS672) as shown. Insert the hole plugs (SS134) into the remaining four holes.
6. There are three ways to connect Uplift Tech depending on your cabinet's electrical options. Make connections as required. These are
detailed on the following page.
7. Go to Section 4 for Final Assembly.
4
© 2019 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
Installation instructions
2a
CB-216-1188 HARDWARE BAG
5
CB-211-1305
QTY: 6
CB-216-1188 HARDWARE BAG
[SS674]
CB-203-1349
QTY: 12
CB-211-1305
CB-SS672
QTY: 6
CB-211-1305
QTY: 6
CB-203-1349
QTY: 12
CB-SS672
CB-SS134
QTY: 6
QTY: 6
CB-216-1188 HARDWARE BAG
CB-SS674
CB-SS712
QTY: 12
QTY: 8
[SS672]
CB-SS672
QTY: 6
[SS134]
CB-SS134
QTY: 6
QTY: 6
5
CB-SS674
QTY: 12
CB-SS136
QTY: 2
CB-203-1126
QTY: 6
CB-SS134
QTY: 6
CB-SS136
QTY: 2
Part no. 209-1311-rB rev. 08/21/19
CB-SS136
QTY: 2
CB-203-1126
QTY: 6
CB-SS712
Uplift Tech Cabinet
Tabla de contenido
