Facom Y.135F Guía De Instrucciones página 14

2. RE-ASSEMBLE THE COLLECTOR :
• Secure Collector End E to Collector Body F .
Use a screwdriver or similar tool to hold the
Collector End in place during re-assembly (see picture below).
• Place the Collector Silencer D onto the Collector End E .
• Place Collector End Cap C on Collector Body End E .
• Install and tighten Collector End Nut D on Collector End E .
TORQUE REQUIREMENTS
Y.135FE30
Y.135FKE Y.135FE40
Y.135FE48
HYDRAULIC OIL CHARGING PROCEDURE
IMPORTANT. TOOL MUST BE DISCONNECTED FROM THE AIR SUPPLY. USE ONLY APPROVED
HYDRAULIC OIL SPECIFIED IN THIS MANUAL.
1. Disconnect from air supply.
➀
2. Remove Nose Housing and Collector
➀
3. Remove four Socket Head Cap Screws using 4mm Hex-Key wrench (Fig. 1).
4. Turn tool upside down and remove Chamber
Then pull out Air Piston Assembly
5. Drain the oil from the tool into a waste oil container.
6. Clean the dirt off the Air Piston Assembly
Apply a thin layer of Seal Lube to inner Chamber.
➄
7. Loosen Jaw Guide approximately 3 full turns or a 0.12''
(3 mm) gap and loosen Fill Screw
turns or a 0.14'' (3.6 mm) gap (Fig. 3).
Nosepiece for rivet Ø 3,0 / 3,2 mm
Nosepiece for rivet Ø 4,0 mm
Nosepiece for rivet Ø 4,8 mm
➁
.
➁
➂
.
➃
. (Fig. 2)
➃ ➂
and inner Chamber
➅
approximately 3 - 3½ full
F
SCREWDRIVER
6,8 - 7,3 N.m
6,8 - 7,3 N.m
6,8 - 7,3 N.m
VIS CHc M4
Fig. 1
➂
➃
Fig. 2
with a clean rag. a clean rag
3,6 mm
➅
Fig. 3
3 mm
➄
14 14