Installing The Unit - Alpine iLX-700 Guía De Referencia Rápida

Installing the Unit

1
Remove the Face Plate from the unit.
2
Mount the original mounting bracket to the
unit using the supplied screws.
Original Mounting Bracket
Fix the Cables etc.
Fix the cables carefully. Do not damage them by tucking them into movable parts, such as a seat rail, or by
locating them against sharp or pointed edges.
Connection Diagram of SPST Switch (sold separately)
(If the ACC power supply is not available)
•
If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold
separately).
•
The diagram and the fuse amperage shown above are in the case when iLX-700 is used individually.
•
If the switched power (ignition) lead of the iLX-700 is connected directly to the positive (+) post of the vehicle's battery, the
iLX-700 draws some current (several hundred milliamperes) even when its switch is placed in the OFF position, and the
battery may be discharged.
8
-EN
Screws (M5 x 8)
(Included)
Face Plate (Included)*
ACC
(Red)
iLX-700
BATTERY
(Yellow)
3
Connect all other leads of the unit
according to details described in the
"Connections" section (page 9).
4
Mounting the unit in a car.
* Use the removed Face Plate if needed.
SPST SW (Optional)
FUSE (5A)
(Optional)
FUSE (20A)
(Optional)
Battery