Environmental Protection - Ryobi EID750RS Manual De Utilización

Ocultar thumbs

página de 83

/ 83
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

OPERATION

DRILLING IN WOOD

To prevent ugly splits around the drill hole on the reverse

side of the workpiece, put a piece of scrap timber under

the work piece.

DRILLING IN METAL

Metals such as steel brass, aluminum sheets, stainless

steel, and pipe may also be drilled. Mark the point to be

drilled with a nail or punch.

Do not use impact drilling mode on these materials.

DRILLING IN CONCRETE

Stone and masonry are generally drilled in the impact

drilling mode.

When drilling in delicate materials such as wall tiles,

it is essential to start with ordinary drilling and, once the

tile is pierced, to continue with impact drilling.

In deep bore holes the drill bit should be pulled out

occasionally in order to remove the debris from the

drill and hole.

AUXILIARY HANDLE AND DEPTH GAUGE

See Figure 6.

Auxiliary handle

The auxiliary handle (8) can be rotated 360º.

Loosen the handle grip by turning in direction (15),

and tighten it at an easy to use position by turning

the grip in direction (14).

Depth gauge

Holes of a fixed depth can be accurately bored by using

the depth gauge (7).

The depth of the hole will be the distance from the end

of the bit to the end of the depth gauge.

By turning the handle grip in direction (14), the depth

gauge can be released and the depth adjusted. After

adjusting the depth, fix the depth gauge again by turning

the handle grip in direction (15).

LIVE TOOL INDICATOR

This tool features a live tool indicator

illuminates as soon as the tool is connected to the power

supply. This warns the user that the tool is connected and

will operate when the switch is pressed.

EID750RS__UM_EU_v1_emc_d1 Sec1:2

English

(11) which

MAINTENANCE

After use, check the tool to make sure that it is in good

condition. It is recommended that you take this tool to

a RYOBI Authorized Service Center for a thorough

cleaning and lubrication at least once a year.

DO NOT MAKE ANY ADJUSTMENTS WHILE

THE MOTOR IS IN MOTION. ALWAYS DISCONNECT

THE POWER CORD FROM THE POWER SUPPLY

BEFORE CHANGING REMOVABLE OR CONSUMABLE

PARTS (BLADE, BIT, ETC.), LUBRICATING OR

WORKING ON THE UNIT.

WARNING

To ensure safety and reliability, all repairs should

be performed by an AUTHORIZED SERVICE

CENTER or other QUALIFIED SERVICE

ORGANIZATION.

S AV E T H E S E I N S T R U C T I O N S F O R F U T U R E

REFERENCE.