Environmental Protection - Ryobi R14DDE Traducción De Las Instrucciones Originales

SPECIAL SAFETY RULES
■ Hold power tool by insulated gripping surfaces
only, when performing an operation where the
cutting accessory may contact hidden wiring.
Cutting accessory contacting a "live" wire may make
exposed metal parts of the power tool "live" and could
give the operator an electric shock.
■ Hold power tool by insulated gripping surfaces
when performing an operation where the fastener
may contact hidden wiring. Fasteners contacting a
"live" wire may make exposed metal parts of the power
tool "live" and could give the operator an electric shock.
INTENDED USE
■ Drilling into
– Wood
– Metal
– Plastic
– Ceramic
■ Driving screws
MAINTENANCE
■ When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
■ Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types
of commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, dust, oil, grease,
etc.
■ Always wear safety goggles or safety glasses with side
shields during power product operation or when blowing
dust. If operation is dusty, also wear a dust mask.
■ To avoid serious personal injury, always remove
the battery pack from the product when cleaning or
performing any maintenance.
■ Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils come in contact with
plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
■ Only the parts shown on the parts list are intended to
be repaired or replaced by the customer. All other parts
should be replaced at an authorized service center.
LED INDICATOR (FUEL GAUGE)
Battery charge
66% - 100%
33% - 66%
LED colour
Green + Yellow + Red
Yellow + Red
< 33%
NOTE: If only the red LED indicator is illuminated, it
means the battery power is low. The battery needs to be
recharged.
BATTERY OVERLOAD PROTECTION
This tool is designed to protect the battery from overloading.
When overloading is detected, the tool will automatically
switch off. To resume operation, switch the tool off and
on again. If the tool fails to operate, it means battery pack
is discharged and should be recharged in a compatible
charger.
e-Torque control
e-Torque contol helps regulate the power output of the drill
to avoid over-driving screws and damaging materials. To
achieve a fl ush fi nish, it is best to select a low setting fi rst
before commencing screw driving. When the e-Torque
control engages, the fuel gauge LED indicator and worklight
will fl ash and the drill will automatically shut down.
If more power is required to drive the screw fl ush, the
e-Torque contol can be adjusted accordingly. e-Torque
control only operates in screw driving mode, it has no effect
on drilling mode.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging should be sorted for
environmental-friendly recycling.
SYMBOLS
GOST-R conformity
CE Conformity
Please read the instructions carefully
before starting the machine.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your local authority or retailer for recycling
advice.
English
Red
1
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
EL
TR