Dairy Center (Some Models); Snack Shelf (Some Models); Temperature Controlled Beverage Chiller ™ (Some Models) - Amana Side-by-Side El Manual Del Propietario

Dairy Center
(some models)
Dairy center provides convenient storage for items such
as butter, cheese, etc.
Dairy Center is adjustable to accommodate storage
needs. Dairy Center may also be removed for cleaning. To
remove Dairy Center perform the following steps:
• Remove Dairy Center cover by opening cover. Push
cover inward at pivot points and pull cover out. Lift Dairy
Center up and pull out to remove.
• Replace Dairy Center by reversing procedure.
Dairy Center
Snack Shelf
(some models)
Snack shelf provides convenient storage for small items
and snacks.
To remove snack shelf lift up and pull out. Replace snack
shelf by sliding in above desired support rail and pushing
down into place.
Snack Shelf
Temperature Controlled Beverage
Chiller ™
(some models)
Temperature Controlled Beverage Chiller
beverages up to 5°F (3°C) colder than refrigerator section.
Air inlet allows air from freezer section to pass to
beverage chiller. Air inlet is located on interior wall of
refrigerator door.
Beverage chiller control is located on left front wall of
refrigerator section. Control adjusts amount of air
circulating in beverage chiller. Turn control to cold* for
normal refrigerator temperature and to colder** for colder
temperature.
A. Refrigerator section left front wall
B. Temperature control
Beverage Chiller™ control
Beverage Chiller position is adjustable to accommodate
storage needs. Beverage Chiller may also be removed for
cleaning. To remove Beverage Chiller perform the following
steps:
• Grasp Beverage Chiller by sides lift up and pull out to
remove.
• To replace, slide Beverage Chiller between desired
shelf rails in door liner and push Beverage Chiller down
into place.
• If Beverage Chiller door track is cleaned, door track
must be lubricated with petroleum jelly for proper
operation of chiller door.
Important
For proper operation of Beverage Chiller, one of the 3
cold air intake holes must line up with notch in right
door dike.
11
™
keeps
A
B