Photos Do Not Capture Subject Of Interest - Bushnell PRIME TRAIL CAMERA Manual De Instrucciones

Photos Do Not Capture Subject of Interest

Check the "Sensor Level" (PIR sensitivity) parameter setting. For warm environ-
1.
mental conditions, set the Sensor Level to "High" and for cold weather use, set the
sensor for "Low".
Try to set your camera up in an area where there is not a heat source in the
2.
camera's line of sight.
In some cases, setting the camera near water will make the camera take images
3.
with no subject in them. Try aiming the camera over ground.
Try to avoid setting the camera up on small trees that are prone to being moved
4.
by strong winds.
Remove any limbs which are right in front of the camera lens.
5.
PIR Sensor LED Flashes/Doesn't Flash
When the camera is in the "AIM" mode, a special LED on the front of the camera
1.
will flash when it senses motion. This is for setup purposes only and will help the
user aim the camera.
During use, the LED will not flash when the camera takes an image. This is to
2.
help keep the camera hidden from game.
LCD Screen Issues
LCD screen powers on but no text is present.
1.
a.After moving the switch from "Off" to "AIM" or "On", make sure that the switch is
correctly in position to ensure the proper mode (avoid positions "between" two
modes).
b.Do not move the switch directly from "On" to "AIM"-always move the switch all
the way down to "Off" first, then back up to "AIM".
LCD screen shows a faint black line after turning from "AIM" to "On".
2.
a. The LCD will turn off when you slide the switch to the "On" position. In some
cases, this black line will appear and then fade in about 1 second. This is normal
and the camera will function properly.
Screen comes on but then powers off
3.
a.Make sure that you have installed the SD card correctly.
Camera won't retain settings
Make sure that you have been saving the changes to any parameter settings that
you made while in Setup mode, by pressing "OK" after changing the setting. If you
don't save your new setting after changing it, the camera will continue to use the
27