Remote Control; Web Server - Promax RP-200 Manual Del Usario

USER'S MANUAL RP-200

5. REMOTE CONTROL

5.1 Web Server

Allows the control of the equipment through a PC connected to a local network,
following these steps:
1) Connect the RP-200 to the local network by means of the
located in the lateral panel.
2) Access to the Web Server using some browser navigator, by entering the specified
instrument IP address. (See section "5.2 Communication setup").
As previous figure shows, the remote control application allows to select the
transmission frequency (FREQ) and level (dBmV) for each pilot carrier to be activated
(ON). Also it is possible, to power off the instrument through activating the (Power off)
option.
08/2006
Figure 5.- RP-200 Web Server.
[7] connector,
ETHERNET
Page 15