Tabla de contenido
Idiomas disponibles
Idiomas disponibles
F
13 Slacken the belt and lift out the centre
pulley.
14 Plug the connector in the machine head
into the socket on the upper drilling co-
lumn.
15 Refit the pulleys and belts, close the
top cover and screw it down.
D
16 Place the machine on its side and plug
the mains power cable into the plug on
the underside.
17 Feed the power cable through the ope-
nings provided on the side required,
ensuring the cable is protected by the
rubber plugs.
•
For safety, the machine should be bol-
ted on to the workbench.
•
Plug the power plug into a grounded
wall socket outlet. The machine is now
ready to run.
O p e r a t i o n
wear personal protective equipment.
Always wear goggles when working
with the machine, to protect your
eyes from flying parts.
Wear a hair net or cap to prevent your hair
from being caught by rotating parts.
S w i t c h i n g o n a n d o f f
H
•
Release the emergency-stop switch
(43) by turning the red knob clockwise.
•
Switch on the machine by pressing the
green On switch (45).
•
Switch off the machine by pressing the
red Off switch (46).
•
In an emergency the machine can be
stopped immediately by pressing the
emergency-stop switch (43).
In an emergency press the emer-
gency-stop switch. The machine
must only be run with the top cover
closed.
L i g h t
•
To switch on the built-in working light
press the light switch (44).
•
To switch off the built-in working light
press the light switch (44) again.
S p e e d s e l e c t i o n
The speed can be adjusted infinitely in two
ranges (fast / slow).
•
Switch on the machine (45).
To adjust the Vario speed the mo-
tor must be running.
•
Detach the motor clamp (B24) on the
right-hand side.
•
Set the speed by adjusting the speed
adjuster lever (A22) on the left-hand
side (1 = slow; 5 = fast)
•
Re-attach the motor clamp (B24) on
the right-hand side.
S e t t i n g „ s l o w " s p e e d
•
Switch on the machine and set the Va-
rio speed to 5 (fast).
•
Switch off the machine and press the
emergency-stop switch.
•
Fit the top cover and tilt it back.
•
Slacken the belt by pushing the speed
adjuster lever to 1 (slow).
•
Mount the front belt on the upper belt
pair.
•
Close the top cover again and screw it
down.
•
Release the emergency-stop switch.
GB
GB-49
Capítulos
Tabla de contenido
