Functional Elements And Controls; Assembly - Rotwerk RB 18 vario Instrucciones De Uso

GB
F u n c t i o n a l e l e -
m e n t s a n d c o n t r o l s
overview
A
1 Top cover
2 Emergency-stop switch
3 Light switch
4 ON button
5 OFF button
6 Drilling spindle with MK 2 mount
7 Drill chuck with tapered mandrel MK2 /
B16
8 Plate
9 Plate locking lever
10 Machine base
11 Fixing holes (6x)
12 Cable gland with plastic guard
13 Mains power cable
14 Flange for column attachment
15 Fixing screws (3x)
16 Plate holder
17 Column
18 Drill chuck guard
19 Circlip for drill chuck guard
20 Clamping screw for drill chuck guard
21 Drilling depth stop with scale
22 Motor adjuster lever (speed adjuster)
23 Section table
B
24 Clamp for motor adjuster
25 Motor terminal box
26 Motor
27 Plate height adjuster locking lever
28 Fixing screw (2x) for column attach-
ment
29 Advance knob
30 Drilling head fixing screw
C
31 Safety switch
32 Front pulley
33 Intermediate plate
34 Vario drive
GB-48
35 Vario drive belt
36 V-belt
D
37 Power cable connector
38 Cable wind
A s s e m b l y
E
1 Mount the column on the base. Make
sure the fixing pin in the column is poin-
ting forward and the upper slot (39) is
pointing to the right.
2 Secure the flange to the base by fixing
screws (15).
3 Secure the column by tightening the
stud screws (28) (2x) on the sides.
4 Fit the plate holder (16) on the column
from above and fix it in place.
5 Fit the plate.
6 Mount the machine head on the drilling
column and fix it in place by the screw
on the side.
7 Screw on the levers for the advance
and the motor adjuster.
8 Mounting the drill chuck:
Degrease the taper bore of the work
spindle, the tapered mandrel and the
taper bore of the drill chuck and push
them firmly together.
The drill chuck does not have to
be additionally secured. It is held in
place adequately by the taper attach-
ment, provided the tapers have been
degreased and correctly joined.
9 Fit the protective disk by first screwing
the holder into the housing and then
tightening the lock nut.
10 Mount the protective disk and fix it in
place with the tommy screw.
11 Affix the circlip so that the disk cannot
drop out when slackened.
12 Fit the top cover and tilt it back.