Installation Requirements; Tools And Parts - KitchenAid Architect Serie Manual De Instalación

Refrigerator
Side Trim
3 / "
8
(9.7 mm)
1 / "
16
(1.5 mm)
1 / "
8
(3.2 mm)
Inset Installation Dimensions
1. Measure the distance from point A (as shown) to the back
wall. Add ¹⁄₃₂ in. (.8 mm) to this measurement to allow the side
panel to fit into the trim.
2. If the panel is more than ³⁄₈ in. (9.5 mm) thick, route the front
edge to allow the side panel to fit into the trim.
A
Overlay
23 3 / "
8
(59.40 cm)
3 / "
16
(4.5 mm)
Recessed Inset Installation Dimensions
1. Measure the distance from point A (as shown) to back wall.
2. Route the front edge of the support board or attach a ³⁄₈ in.
(9.5 mm) board to hold the panel in the cabinet side trim.
A
INSTALLATION
REQUIREMENTS

Tools and Parts

IMPORTANT:
Installer: Leave Installation Instructions with the homeowner.
Homeowner: Keep Installation Instructions for future
reference. Save these Installation Instructions for the local
electrical inspector's use.
Tools needed:
Make sure that you have the tools necessary for proper
installation:
Hand drill or electric drill
(properly grounded)
Drill bits
Two adjustable wrenches
Phillips screwdriver
Small level
Appliance dolly
Parts needed:
6 - #8 x 3 in. (7.6 cm) wood screws (longer screws may be
needed)
1 or 2 - 2 in. x 4 in. x 32 in. (5 cm x 10 cm x 81 cm) wood
board(s)
Order factory panels, make custom panels or consult a
qualified cabinetmaker or carpenter to make the panels.
Classic Series: Order factory panels, make custom panels, or
consult a qualified cabinetmaker or carpenter to make the
panels. See "Design Specifications" for more information.
Overlay Series: Make custom panels, or consult a qualified
cabinetmaker or carpenter to make the panels. See
"Installation Requirements" and "Design Specifications" for
more information.
Pro Line™, Complete and Architect
complete.
If you are connecting the water line directly to copper tubing
and not to a shutoff valve, you need a ferrule, a union, and a
¹⁄₄ in. (6 mm) compression fitting.
T27 flat-head 6 point
driver
¹¹⁄₃₂ in. nut driver
³⁄₈ in. and ¹⁄₂ in. open-end
wrenches
⁵⁄₃₂ in. Allen wrench
⁵⁄₁₆ in. socket wrench
Tape measure
® Series are shipped
15