Step 12, Connect Water Supply; Step 13, Turn On The Power - GE Profile PSB42LGRWV Instrucciones De Instalación

12 CONNECT WATER SUPPLY
Check to make sure that Master Power switch is in
the O (OFF) position.
Refrigerator
Water Supply
• Locate and bring GE SmartConnect tubing to the
front of the cabinet.
• Turn the water on to flush debris from line. Run
about a quart of water through tubing into a bucket,
then shut off water.
Copper Tubing
• Slip a 1/4" nut and ferrule onto end of copper tubing. Insert tube into the union fitting on the unit and tight-
en nut to union.
• Turn on the water to check for leaks.
GE SmartConnect™ Tubing
• Insert the molded end of the tubing into the refriger-
ator connection. Tighten the compression nut until it
is just hand tight.
• Tighten one additional turn with a wrench. Over-
tightening can cause leaks.
• Turn on the water to check for leaks.
Note: Make sure excess tubing length does not
interfere with toekick installation.
Installation Instructions
House
Water Supply
19
13 TURN ON THE POWER
• Set the Master Power switch to the I (ON) position.
• Check to make sure power to refrigerator is on by
opening refrigerator door to see if interior lights
are on.
Raise
Grille
Panel
Master
Power Switch
• The temperature controls are preset at 37° for the
Fresh Food section and 0° for the Freezer section.
• Allow 24 hours to stabilize before making any
adjustments.
Water Filter