Step 5, Connect Power; Space; Step 7, Level Refrigerator - GE Profile PSB42LGRWV Instrucciones De Instalación

5 CONNECT POWER
• Connect refrigerator power cord plug to a properly
grounded receptacle. Set the Master Power switch
to the I (ON) position.
Raise
Grille
Panel
Master
Power Switch
• Check to make sure power to refrigerator is on by
opening refrigerator door to see if interior lights
are on.
CAUTION:
• After power has been established, turn the Master
Power switch to the O (OFF) position.
6 MOVE INTO
INSTALLATION SPACE
• Slide the unit into the installation space.
• Place excess slack in the power cord on top of the
refrigerator.
• Use care to ensure the power cord is not pinched
behind the unit.
Installation Instructions
Water Filter
Height
from
Floor to
Bottom
of Wood
Block
82"
7 LEVEL REFRIGERATOR
All models have 4-point leveling. The front and back
are supported by leveling legs. Both are accessible
from the front of the refrigerator.
• To level the back of the refrigerator, turn the 1/2"
hex nut located above the front wheels. Turn
clockwise to raise or counterclockwise to lower
the refrigerator.
• For front leveling, use a 7/16" open-end wrench.
• Adjust height of refrigerator to match installation
cutout opening 83-1/2" to 84-1/2". The refrigerator
should be level and plumb with cabinets.
Leveling Leg
CAUTION:
The rear leveling legs and front leveling legs are
limited to a maximum height adjustment of 1". If the
installation requires more than 84-1/2" height, the
installer should elevate the refrigerator on a sheet
of plywood or runners. Cabinet trim could be
added across the top of the opening to shorten the
opening. If you attempt to raise the refrigerator
more than 1" you will damage the front and rear
leveling legs.
16
Hex Nut Adjusts
Rear Leveling
Legs