Automated Learning Process./Activating Code; Remote Control - Craftmade Katana KAT72ESP9 Guia De Instalacion

10. Automated Learning Process./Activating Code.

LED LIGHT
FAN OFF
FAN SPEED
REVERSE
UP LIGHT
LIGHT KIT
CODE
SWITCHES
DIMMER
SWITCH
Install 12-volt battery (provided) in transmitter and wall control (if applicable).
IMPORTANT: Store the transmitter away from excess heat or humidity. To prevent damage to transmitter,
remove the battery if not used for long periods.
LED LIGHT:
FAN SPEED, Buttons 1-6:
REVERSE:
CODE SWITCHES and LEARN button: With fan power OFF, set CODE SWITCHES on handheld remote control
UP-LIGHT:
LIGHT KIT:
DIMMER SWITCH:
FAN OFF:
ON/OFF slider switch:
Select faceplate for remote control and/or wall control and press firmly onto front of remote control/wall control.
IMPORTANT: The Automated Learning Process takes 5 minutes to complete. Please leave the fan "on"
for the duration of the 5-minute programming and do NOT use the remote control during
this time.
REMOTE
CONTROL
3 4
5
2
1
6
LEARN
12V
Comes on when any button is pressed.
Use to control the ceiling fan speed 1-6.
Use to control fan direction.
and wall control to desired code setting. Turn fan power on. Within
30 seconds of powering fan, press and hold LEARN button on remote
control and/or wall control for 5 seconds (or until fan beeps twice) in
order to synchronize remotes with fan motor.
Use for up-light (if applicable).
Use for light kit (if applicable).
Dimming capability is determined by the type of bulbs provided with
the light kit.
ON position = D
Use to turn fan off.
[Wall control only] Use to turn wall control on or off.
IMPORTANT:
Remote and wall
controls must be
SYNCHRONIZED with
fan in order to
properly function.
IMPORTANT:
The code switches in
remote and wall
controls MUST MATCH
for fan to function
properly.
OFF position = O
page 8
WALL
CONTROL
LED LIGHT
3 4
2
5
1
6
CODE
SWITCHES
DIMMER
SWITCH
12V
FAN OFF
FAN SPEED
REVERSE
UP LIGHT
LIGHT KIT
ON/OFF
SLIDER
SWITCH
LEARN