Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6. Wiring. (cont.)
[PLEASE NOTE: Wall and/or handheld remote
control must be used for fan to operate. If you
do not wish to use the wall control, please proceed
to Section 7 below to continue with fan
installation.]
To install wall control, remove existing wall
switch. Wire one of the wall controls with wire
connectors provided as shown in diagram at
right.
*Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently push wires and taped wire connectors
into outlet box.
Install one 12-volt battery (included) in wall
control.
IMPORTANT: Wall control will not function
unless battery is installed.
Since this fan comes with LED bulbs, the
dimmer switch (labeled D and O) has been
pre-set to the "ON" position (D). If you do not
wish to have dimming capability, please move
the switch to the "OFF" position (O).
Attach wall control to outlet box and secure
with screws from original wall switch. Attach
plate (included) to wall control using 2 screws
provided with the wall control.
7. Canopy Assembly.
Raise canopy to hanging bracket and align
slotted holes in canopy with loosened screws in
hanging bracket. Twist canopy to lock. Re-insert
screws previously removed (on page 3, Section
4) and secure all screws with a Phillips
screwdriver.
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
*
Reorient or relocate the receiving antenna.
*
Increase the separation between the equipment and receiver.
*
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
outlet box
green/
bare
ground
black
black
(AC IN from
breaker box)
(wiring for wall control)
page 6
wall
control
3 4
2
5
1
6
green
LEARN
black (OUT to fan)
black
(TO POWER supply)
hanging bracket
canopy
plate
Capítulos
Tabla de contenido
