Testing Your Fan - Craftmade Katana KAT72ESP9 Guia De Instalacion

11. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Test wall control
(optional installation) by locating ON/OFF
slider switch on wall control, then set to ON
position. Test light ON/OFF and then test fan
speeds. Next, locate remote control. Start
with the light OFF and test the light ON/OFF
function button. Test fan speed with different
fan speed buttons (1 - 6). Next, locate
handheld remote control. Test fan speeds
with the different fan speed buttons (1 - 6) on
handheld remote control. Test the light
ON/OFF function by pressing the button;
test the dimmer function by pressing the
button and holding it down for 1 second.
If the remote control operates the functions
of the fan and light, batteries have been
installed correctly. If the wall and/or remote
control do (does) not operate the fan/light
functions, refer to "Troubleshooting" section
to solve any issues before contacting
Customer Service.
Fan must be on LOW before setting the fan in
reverse. Use button to recirculate air
depending on the season. A ceiling fan will
allow you to raise your thermostat setting in
summer and lower your thermostat setting in
winter without feeling a difference in your
comfort.
NOTE: If the wall/remote control interferes
with other appliances, change code switches
on the wall/remote control to another code. If
you do change the code, turn power off first.
After setting the new code on the
wall/remote control, go back to the
instructions for the LEARN button in
Section 10 (page 8).
IMPORTANT: Remote control (and wall
control, if applicable) must be synchronized
with fan in order to properly function.
page 9