Accessories - Weller Lötkolbenset WP 65 Instrucciones De Uso

WP 65
PK Elektronik Vertriebs GmbH, E-Mail: [email protected], Internet: www.pkelektronik.com
Replacing a used soldering tip
1. Place the soldering tool in the WDH 10 safety rest.
2. Switch off the supply unit.
3. Wait three minutes until the soldering tip has cooled off.
4. Hold the soldering iron with the tip angled slightly downwards.
Hold the soldering iron by the rear handle and unscrew
the barrel (3) by turning anticlockwise
Pull off the barrel (3) forwards
The soldering tip (2) is now loose in the barrel (3)
Note Do not set the soldering tip / measuring down or allow it to cool on
the metal wool or plastic surfaces. When using more than one type
of soldering tip, it is recommended that the soldering tip (2) and the
barrel (3) be used together in the changer system (see 3, figure
above).
Keep the heat transfer surfaces of the soldering tip and heating
element clean. The heating element must not come into contact with
soldering tin.
Inserting a new soldering tip
5. Place the soldering tip into the tip receptacle with the tip pointing
forwards. Push the tip receptacle together with the soldering tip
over the heating element and rotate clockwise to tighten.
6. Switch on the supply unit and set the required temperature.

7 Accessories

7.1 XNT soldering tips for the WP 65 soldering iron
See the table XNT soldering tips for WP 65 soldering iron in the
section in the back and at www.weller-tools.com.
7.2 Replacement parts and accessories for
WP 65
Order no.
T0052921199
T0051512199
T0051516199
T0051384199
Description
WP 65 soldering iron
WDH 10 safety rest
WDH 10T safety rest
Metal wool for cleaning element for WDC 2
7-8