Accessing The Control Unit Settings; Programming The Limit Switches - V2 ATRIS Manual Del Usuario

10 - ACCESSING THE CONTROL UNIT
SETTINGS
1. Press and hold the OK key until the display shows the menu
desired
-FC
Programming the limit switches (chapter 10.2)
-SEn
Automatic sensitivity adjustment (chapter 10.3)
-PrG
Programming the control unit (chapter 12)
-Cnt
Cycle counter (chapter 11)
-dEF
Loading the default parameters (chapter 8)
2. Release the OK key: the display will show the first item in the
sub-menu
m
WARNING: in case no operation is carried out for
more than one minute, the control unit exits from the
programming mode without saving any of your setups and
changes, which will get lost.
-FC
2''
-SEn
4''
-PrG
6''
-Cnt
8''
-dEF
10''
- - - -
12''
fC A
SEnS
En.SA
tot
ESC
- 36 -
10.1 - PROGRAMMING THE LIMIT
SWITCHES
1. Press and hold the OK button until the display shows
2. Release the OK button: the display shows
(opening limit switch)
FC A
3. Press OK: flashes
i
4. Press and hold the key
or
reaching the position of the opening limit switch
5. Press OK to confirm: the display shows
i
6. Press the key: the display shows
FC C
7. Press OK: flashes
i
8. Press and hold the key or
reaching the position of the closing limit switch
9. Press OK to confirm: the display shows
i
10. Press the
key : the display shows
11. Press OK: the display shows no
i
12. Press the key: the display shows
13. Press OK: the limit switches are stored and the display shows
the menu for programming the
the next page
NOTE: we recommend you to configure both limit switches
in a single programming session
-FC
FC A
FC C
SAvE
no
Si
-FC
FC A
h
and move the gate until
FC A
FC C
(closing limit switch)
h
and move the gate until
FC C
SAvE
Si
SEnS
sensitivity reported on
FC A
FC C
SEnS