Control Unit; Collegamenti Elettrici; Electrical Connections - V2 ATRIS Manual Del Usuario

8 - CONTROL UNIT

PD22 is provided with a display that, not only makes
programming simple, but also allows a continuous monitoring of
the input statuses; in addition, thanks to a menu structure, the
working schedule and the operation logic can be set easily.
In compliance with the European standards concerning
electrical safety and electromagnetic compatibility
(EN 60335-1, EN 50081-1 and EN 50082-1) it has been
equipped with the low voltage circuit total electric insulation
(motors included) from the network voltage.
Other characteristics:
• Power supply protected from short circuits within the
controller, on the motors and on the connected accessories.
• Detecting obstacles by monitoring the current on the motors
(current sensing probe and encoder)
• Automatic learning of the limit switches position.
• Tests for safety devices (photocells, safety edges and mosfet)
before each opening.
• Deactivation of safety inputs through the configuration menu:
no jumper is required for terminals concerning safety devices
that have not been installed, yet. You will only need to disable
this function from its relevant menu.
• Low voltage output that can be used for a signal light or a
24V flashing light.
• Built-in LED courtesy light.
• ENERGY SAVING function
m
WARNING: Installation of control unit and safety
devices must be carried out with power disconnected

8.1 - ELECTRICAL CONNECTIONS

L1
Antenna
L2 Antenna shield
START - Open command for connecting
L3
traditional devices with N.O. contact
L4 Photocell. N.C. contact (disabled by default)
Configurable safety input:
L5 - STOP button. N.C. Contact (disabled by default)
- Safety edge (disabled by default)
L6 Common (-)
L7
+24Vdc supply for photocells and other accessories
L8
Accessory power common (-)
+24Vdc supply - photocell/optical edge TX for
functional Test.
L9
Connect power supply cables of photocells
transmitter between terminals L7 and L8
L10
Flashing light 24V / Warning light 24V (+)
L11
Flashing light 24V / Warning light 24V (-)
BATTERY
B-PACK or ECO-LOGIC back-up battery pack
RECEIVER
Connector for MR receiver
ADI ADI Module interface
OVERLOAD Overload LED indicator light on supply line
G1 MR2 receiver LED indicator light
Automation status LED indicator light
STAND-BY: 1 blink every 2"
G2 OPENING: flashing 2Hz
CLOSING: flashing 2Hz
PAUSE: lit
- 30 -