Installation Of Guide Section Bar - V2 ATRIS Manual Del Usuario

4 - INSTALLATION OF
GUIDE SECTION BAR
1. Remove the section bar from its
cardboard packaging and check its
integrity.
2. Unfold the section bar as indicated in
the figure below.
3 Once the section bar is elongated, slide
the connecting section bar R to the end
position indicated by the two holes Q
on the chain-guide section bar.
4. Adjust the tension of the chain/belt
using the Allen-head screw with a
10 mm Allen-wrench: turn the bolt until
the chain/belt is sufficiently tight.
m
CAUTION: After tensioning the
chain/belt make sure the drive carriage
slides freely throughout the length of
the guide.
Eliminate any friction prior to
proceeding with the next phases of
installation.
Q
- 27 -
Q
R