ADDITIONAL SAFEGUARDS
WARNING: This appliance generates heat and escaping steam during use.
Proper precautions must be taken to prevent the risk of burns, fires, or injury to persons
or damage to property.
Never immerse or rinse this appliance in water or any other liquid.
If this appliance accidentally falls or becomes immersed in water, unplug it
immediately and do not reach into the water.
Always use oven mitts when touching and/or removing the Lid or accessories.
To reduce the risk of injury, unplug this appliance before inserting food. Always keep
the appliance unplugged when not in use.
Be sure to provide adequate space for air circulation above and on the sides when
using this appliance. Do not operate near curtains, wall coverings, clothing, dish
towels or other flammable materials.
To reduce the risk of fire, do not leave this appliance unattended during use.
Do not attempt to repair a malfunctioning appliance.
Do not place any of the following materials in the Rotisserie: paper, cardboard,
plastic, and the like.
Do not attempt to dislodge food or clean the Rotisserie while it is plugged in or still
hot.
Do not clean with metal souring pads. Pieces of the pad may break off and touch
electrical parts, creating a risk of electric shock.
Do not attempt to use this appliance without the Lid in place.
ALCI Safety Device (On the Plug)
The ALCI safety device is equipped with a test button so that its operation can be checked.
TO USE:
1. Press the reset button on the ALCI safety device.
2. Plug appliance into AC electrical outlet.
3. Then press the test button. The reset button will pop out. This verifies that the safety device is
operating properly. Should the reset button not pop out, do not use the unit. Return
immediately for service.
Press the reset button to re-activate your ALCI safety device and use your appliance. Repeat this
procedure each time this appliance is used, to confirm that the safety device is operational.
At any time, should this unit detect an electrical shock hazard, it will immediately shut off. To
restore power, you MUST press the reset button on the ALCI safety device to reactivate the
circuit.
THE ELECTRICAL CORD
To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.
The cord length of this appliance has been selected to reduce the possibility of tangling or
tripping over a longer cord. If additional cord length is needed, an extension cord rated not less
than 15 amperes, 120 volts and with the Underwriters Laboratories listing, may be used. If using
an extension, be sure to arrange it so that it cannot be pulled or tripped on.
3